Please order early for the upcoming unprecedented Holiday Season. Increased package volumes amid supply shortages are causing delays in shipping and delivery. Order your Christmas Gifts Early!

RANCHO ATV Deer and Game Feeder

RANCHO ATV Deer and Game Feeder



Bring them to you. These feeders dispense deer corn in an even uniform flow to make a trail to your tree stand or ground blind.  Unlike other feeders, the RANCHO feeder does not fling the corn everywhere along the trail. A simple inexpensive way to spread your deer corn, feeder grains, and pellets by using a truck, ATV, tractor, or even a pull behind a wagon.

These gravity feeders feature a rope operated spring trap door, attached to a drain tube. The drain tube is specially designed to allow clean deer corn to flow slowly, but not too small to cause clogging. Pull the rope intermittently or steady to leave a trail straight into your hunting blind.

Read more below >

* Required Fields


Select either the 2” standard receiver model or the ATV model with a versatile adjustable bracket to mount on an ATV rack, flat hitch, bumper or on a side running board.  The price above is for the 2" standard hitch. The ATV model is $19 more for the metal mounting bracket. The feeder measures 21-1/2 Tall x 12-1/2” in diameter (Just about the size of a 5-gallon bucket).

The Rancho Feeder comes with a lid that is held tightly in place with two durable tie-downs. Mount it on your truck or ATV, fill it and be road-ready.

The versatile adjustable bracket ATV model features an adjustable slide mount allowing up to 9” of adjustment up or down, the bracket can also be reversed to hang down. The mounting plate provides a 1-1/2” x 2” surface to drill mounting holes, clamp with vise grips, a c-clamp, or weld onto another hitch assembly. The ATV model comes with a short pull rope for the operator to reach back and use, a longer rope can be purchased at any local hardware store. Select ATV Model or Standard 2" receiver above. 

Note: The 2” receiver model extends 4” into the standard hitch receiver and comes with a hitch pin and key. It will require at least 21-1/2” clearance measured from the bottom of the hitch receiver. If your ATV has a hitch that is recessed in under the front bumper or back in under the cargo box, a hitch extender will be required. If you do not want to go to the expense of a metal factory made extender, the male end of the feeder is made of 100% high-density polyethylene, which is hollow inside. The end can be cut off to accept a wooden or metal tube extender, which then can be bolted through the original hitch pinhole. A hardwood such as Oak is recommended. Although the hitch is made of polyethylene it is strong enough to hold a 200lb man standing in the feeder. The 2” receiver model comes with a long enough rope to run up to a truck cab for the operator to drive and pull open the trap door.

You will need to use clean feed free of stems and debris that may clog the gravity flow of feed.


Each feeder comes completely assembled and ready to use.  

Click Here for a replacement trap door assembly.  Hunters sometimes forget they have the feeder on the back of their ATV and back into brush damaging the trap door

Shipping Estimator

Estimate Shipping Cost

Note: If the product has any options with * Required Field(s) in the drop-down box options above they must be selected to obtain a shipping estimate.

Note: Use the shipping estimator at checkout if other products are already in the shopping cart. This single product estimator will no longer provide a correct combined shipping estimate with other items.


Be the first to review this product

Write Your Own Review

Only registered users can write reviews. Please, log in or register

You may also be interested in the following product(s)